To be certified The Arizona Business Management exam must be taken as well.

SCOPE OF WORK
Low Voltage Communication Systems Scope of Work: Installation and repair of low voltage alarm, intercom, telephone, call, clock and television systems, including towers and antennas.
Installation, service, repair, and maintenance of systems and devices of low voltage including: public address; intercommunication systems; telephone switchboards; call systems; master and program clocks (low voltage wiring and needed equipment only); electrical teaching devices; low voltage signaling; master television antennas; closed circuit television; and alarm systems. Installation, service, repair, and maintenance of both high and low level electronic or electrical control devices that are associated with systems of low voltage. Erection of towers on buildings for television antennas.

The exam is 60 Questions taken over 120 minutes. The minimum required score to pass is a 70%

The reference material listed above was used to prepare the questions for this examination. The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available. For Code questions, the examinations will be based only on the edition of the Code book that is listed.

Candidates may use a silent, nonprinting, non-programmable calculator in the examination center.

The first 3 materials may be brought into the exam center the last 8 may not. 

The following reference material is allowed in the examination center:

Code of Federal Regulations - 29 CFR Part 1926 (OSHA)

NFPA 70 – National Electrical Code, 2008

NFPA 72 – National Fire Alarm Code, 2007

The following reference material is not allowed in the examination center:

Low Voltage Wiring: Security/Fire Alarm Systems

Telecommunications Wiring, Clyde Herrick, 2001, 3rd Edition

Understanding and Servicing Alarm Systems, 1999, 3rd Edition

Live Sound Reinforcement: A Comprehensive Guide to P.A. and Music Reinforcement Systems and Technology, Scott Hunter Stark, 2002, 2nd Edition

Data, Voice, and Video Cabling

Antenna Toolkit, Joe Carr, 2001, 2nd edition

Practical Home Theater - A Guide to Video and Audio Systems, Mark Fleischmann, 2007

Telecommunications Distribution Methods Manual

Candidates are responsible for bringing their own references to the examination center. Reference materials may be highlighted, underlined, annotated and/or indexed prior to the examination session. However, references may not be written in during the examination session. Any candidate caught writing, highlighting, underlining and/or indexing in the references during the examination will be reported to the Arizona Registrar of Contractors. Furthermore, candidates are not permitted to bring in any additional papers (loose or attached) with their approved references. References may be tabbed/indexed with permanent tabs only. (permanent tabs are defined as tabs that would tear the page if removed). Temporary tabs, (defined as Post-It notes, or other tabs that may be removed without tearing the page) are not allowed and must be removed from the reference before the exam will begin. If you are downloading from the Internet, you may bring this reference into the testing center with you as long as it is bound. You can have it spiral bound or you may hole-punch it and put it in a binder.