The candidate may supervise all work necessary to the assembling, installation, erection, operation, maintenance, or repair of all electrical apparatus, devices, wires, cables, supports, insulators, conductors, duct, and raceways when they are part of distribution systems outside of buildings and are outside of property lines of any given property up to and including the primary side of transformers; all underground ducts and cables when they are part of a system of a distributing company or utility; all outdoor substations and electrical connections up to and including the setting of transformers and the connecting of the primary busses to them; all outdoor street lighting on public thoroughfares, roadways, and rights-of-way; all linework consisting of wood, concrete, metal, or substitutes for those materials; and all linework consisting of poles or towers, including wires, cables, or other apparatus supported by them.
The exam is 100 questions taken over 240 minutes. The required minimum score is a 70% which means that 70 questions must be answered correctly to pass.
The reference material listed above was used to prepare the questions for this examination. The examination may also contain questions based on trade knowledge or general industry practices. Except for Code books, you can base your answers on later editions of references as they become available. For Code questions, the examinations will be based only on the edition of the Code book that is listed.
Candidates may use a silent, nonprinting, non-programmable calculator in the examination center.
The first six books may be brought into the exam center, the last two may not be brought into the exam center
The following reference material is allowed in the examination center:
Alaska Centralized Regulations, Alaska Department of Commerce
Alaska Centralized Statutes , Alaska Department of Commerce
Alaska Construction Contractor Statutes and Regulations (AS 08.18; 12 AAC 21)
Alaska Electrical Administrator Statutes and Regulations (AS 08.40; 12 AAC 32)
National Electrical Code, 2014
NFPA 72 – National Fire Alarm Code, 2013
Code of Federal Regulations - 29 CFR Part 1926 (OSHA)
Candidates are responsible for bringing their own references to the examination center. Reference materials may be highlighted, underlined, annotated and/or indexed prior to the examination session. However, references may not be written in during the examination session. Any candidate caught writing, highlighting, underlining and/or indexing in the references during the examination will be reported to the Department. Furthermore, candidates are not permitted to bring in any additional papers (loose or attached) with their approved references. References may be tabbed/indexed with permanent tabs only. (Permanent tabs are defined as tabs that would tear the page if removed). Temporary tabs, (defined as Post-It notes, or other tabs that may be removed without tearing the page) are not allowed and must be removed from the reference before the exam will begin. If you are downloading from the Internet, you may bring this reference into the testing center with you as long as it is bound. You can have it spiral bound or you may hole-punch it and put it in a binder.
|title=Reference Materials| national-electrical-code-2014|alaska-centralized-regulations-alaska-department-of-commerce-community-and-economic-development|alaska-centralized-statutes-alaska-department-of-commerce-community-and-economic-development|statutes-and-regulations-construction-contractors|alaska-electrical-administrator-statutes-and-regulations|national-electrical-safety-code|american-electricians-handbook-sixteenth-edition|lineman-s-and-cablemans-handbook-shoemaker-and-mack|title=Application Service|application-service|
